Configuring The Snmp Function - Tenda i21 User Manual

8.2 Configuring the SNMP Function

Choose SNMP and set SNMP Agent to Enable.
Step 1
Set related SNMP parameters.
Step 2
Click Save.
Step 3
--End
Parameter description
Parameter
SNMP Agent
Administrator Name
Device Name
Location
Read Community
Read/Write Community
Description
It specifies whether to enable the SNMP agent function of the AP. By default, it is
disabled.
An SNMP manager and the SNMP agent can communicate with each other only if
their SNMP versions are the same. Currently, the SNMP agent function of the AP
supports SNMP V1 and SNMP V2C.
It specifies the name of the administrator of the AP. The default name is
Administrator. You can change the location as required.
It specifies the device name of the AP. The default device name is the model of
the AP.
It is recommended that you change the AP name so that you can easily identify the AP
when managing the AP using SNMP.
It specifies the location where the AP is used. You can change the location as
required.
It specifies the read password shared between SNMP managers and this SNMP
agent. The default password is public.
The SNMP agent function of the AP allows an SNMP manager to use the password
to read variables in the MIB of the AP.
It specifies the read/write password shared between SNMP managers and this
SNMP agent. The default password is private.
The SNMP agent function of the AP allows an SNMP manager to use the password
to read/write variables in the MIB of the AP.
80