Button And Port; Label - Tenda i21 User Manual

1.2.2 Button and Port

Button & Port
LAN port
Power jack
Reset button

1.2.3 Label

The label is located on the rear panel of the AP. For details of the label, see the following figure.
(2)
(4)
Connection Description
10/100 Mbps auto negotiation port

If the AP is powered using a DC adapter, connect this port to a switch.

If the AP is powered through PoE, connect this port to an IEEE 802.3af/at PoE
switch.
The AP allows a maximum PoE power supply distance of 100 meters.
The power jack is used to connect to a DC adapter for supplying power to the AP.
Input: 12 V 1 A
After the AP is powered on, you can hold down this button for 8 seconds to
restore the factory settings.
Position of the label
Power jack
2
Reset button
LAN port
(1)
(3)
(4)
(5)
(6)