Energetics POWER RUN 14.0 HRC Owner's Manual page 7

Lubrication
It is important to take good care of your treadmill deck (the walking surface underneath the belt). Good silicone
lubrication will also improve the performance of your treadmill.
How to spray silicone on deck?
1. Find the silicone bottle. Part of the hardware kit included in the carton. For replenishment please consult your
local dealer.
2. Find a straw and put on silicone bottle (see picture 2.)
3. Spray silicone on treadmill deck even, they spray area is shown on picture 3.
ATTENTION: always STOP the treadmill before spraying silicone, otherwise severe injuries might result and/or
the treadmill may get damaged. To be 100% safe unplug the treadmill before adding
lubrication.
Do not put too much silicone on deck, only a few drops on several locations is sufficient. Slippages can be
caused by too much lubrication.
Silicone bottle
Belt Adjustment
If running belt is against U shape side rein after adjusting running belt, to adjust U shape side rein will be
needed.
The steps are as the following:
A. Loosen (reverse direction) the four M4x25L (mm) screws upon the back cover (see figure 1).
B. Hands hold U shape side rein, and pull backward. Make the space maintain 5 to 7mm between U shape side
reins and running belt (see figure 2).
C. Tighten the four M4x25L (mm) screws.
M4x25L
Put on straw
BACK OVER
WRENCH
Spray area
RUNNING BELT
7
SPACE: 5~7mm
SIDE REIN