Erickson 07488 Manual

Aluminum Combination Loading Ramp
To avoid personal injury and/or property damage, please read and follow
1. Never overload ramps. Maximum capacity for your ramp is 1500 lb. (Evenly distributed load).
2. Always use safety strap to securely fasten the ramp to the vehicle. This prevents the ramp from
slipping off the back of the truck.
3. Carefully roll or winch equipment up or down the ramp. Never drive or ride your equipment while
loading or unloading. Erickson Manufacturing is not responsible for any damage or injuries that can oc-
cur when loading and un-loading. USE AT YOUR OWN RISK!
4. Make sure the ramp is aligned with the wheels of the equipment being loaded or unloaded.
5. Always load or unload on a solid, level and stable surface with the vehicle in gear, the parking/
emergency brake on, and engine off.
6. Use as a loading ramp only.
7. Ramp surfaces must be clean, dry and free from oil, grease or water.
8. Maximum recommended height is 30 inches.
9. Inspect ramp before each use. Tighten any loose hardware. Replace any worn or damaged parts.
Replace safety strap if webbing is frayed or worn. Do not attempt to use a ramp that is damaged
in any way. No modification, alteration, or deviation to the ramp are authorized by the manufacturer.
Proper care and maintenance of the ramp are essential to safety.
10. Proper use of this product is critical to safety, and beyond the control of Erickson Manufacturing
Ltd. Erickson Manufacturing Ltd. neither guarantees nor is liable for any damage resulting from
improper use. The liability of this product is limited to its purchase price if it proves to be defective
in material and/or workmanship.
IMPORTANT NOTICE ABOUT LOADING ON A TAILGATE
• Erickson Manufacturing does not recommend the loading or
unloading of equipment on a tailgate.
• It is recommended that if you choose to load or unload using a
tailgate that you take the proper precautions and support your
tailgate with a approved Tailgate Support.
• For more information visit
ALL instructions before assembling and operating.
AVERTISSEMENT
NE JAMAIS MONTER SUR L'ÉQUIPEMENT DURANT LE
CHARGEMENT OU LE DÉCHARGEMENT
PEUT PROVOQUER DES BLESSURES OU LA MORT
www.dgmtailgatesupport.com
Item no: 07488
Page 1/4