Husqvarna PG 830S Operator's Manual page 16

• Position 2: Standard pressure on the grinding head.
• Position 3: Minimum pressure on the grinding head.
This position is also used when you tilt the product to
servicing position.
To assemble and disassemble the weights
The product has 1 weight on each side of the product.
Do the procedure that follows on each weight.
1. Install the weight holder and tighten the 4 screws.
16
2. Install the 2 weight brackets. Make sure that the
weight brackets are installed correctly as shown in
the illustration.
3. Put the weight on the cylinder (A) on the weight
holder.
4. Attach the weight gas spring to the product (B).
a) Remove the locking spring of the ball joint.
b) Remove the ball joint from the gas spring.
c) Attach the ball joint to the product.
d) Attach the gas spring to the ball joint. Lock the
gas spring to the ball joint with the locking spring.
A
B
1253 - 003 - 22.01.2020