Supermicro X11SCL-F User Manual page 46

Super X11SCL-F User's Manual
Standby Power
The Standby Power header is located at JSTBY1 on the motherboard. You must have a card
with a Standby Power connector and a cable to use this feature. Refer to the table below
for pin definitions.
Overheat/Fan Fail LED Header
The JOH1 header is used to connect an LED indicator to provide warnings of chassis
overheating and fan failure. This LED will blink when a fan failure occurs. Refer to the tables
below for pin definitions.
Overheat LED Header
Status
State Definition
Solid Overheat
Blinking Fan Fail
ASpeed
AST2500
LEDBMC
2
MH11
SP1
MH10
BT1
USB2/3
JBT1
USB4/5
Intel
C242
M.2 PCI-E 3.0 X4
JTPM1
I-SATA0 I-SGPIO1
LE3
I-SATA1
I-SATA2
JSD1
I-SATA3
JSD2
Standby Power
Pin Definitions
Pin# Definition
1 +5V Standby
2 GND
3 NC
VGA
LAN2 LAN1
Intel
i210
X11SCL-F
REV:1.01
DESIGNED IN USA
CPU
MEGERAC
LICENSE
JF1
LEDPWR
JSTBY1
1
Overheat LED
Pin Definitions
Pin# Signal
Pull high to +3.3V
1 power through 330-ohm
resistor
2 OH Active
1. Standby Power Header
COM1
2. Overheat/Fan Fail LED
IPMI_LAN
USB0/1
MAC CODE
BAR CODE
46
Header