Table of Contents
Advertisement
Installing the Device
2.4 Connecting the Failsafe Alarm Relay
2.
3.
2.4
Connecting the Failsafe Alarm Relay
The failsafe relay can be configured to latch based on alarm conditions. The NO
(Normally Open) contact is closed when the unit is powered and there are no ac-
tive alarms. If the device is not powered or if an active alarm is configured, the relay
opens the NO contact and closes the NC (Normally Closed) contact.
Note
Control of the failsafe relay output is configurable through RUGGEDCOM RS930W .
One common application for this relay is to signal an alarm if a power failure oc-
curs. For more information, refer to the RUGGEDCOM RS930W User Guide for the
RUGGEDCOM RS930W.
To connect the failsafe alarm relay, do the following:
1.
12
Place the device against the panel and align the adapters with the mounting
holes.
1
1
Screw
1
Panel Mount Adapter
2
Figure 2.3
Panel Mounting
Secure the adapters to the panel with #6-32 screws.
Insert the failsafe alarm relay terminal block into the device and tighten the
screws.
2
2
Installation Manual, 02/2020, C79000-G8976-1035-07
RUGGEDCOM RS930W
Advertisement
Table of Contents
