Datamax A-4310 Programmer's Manual page 96

(RI) RFID Configuration – This command configures the optional RFID interface module, as follows:
Value Units / Interpretation
where n:
Mn
where hh:
AIhh
and where n:
ALn
where hh:
DIhh
and where n:
DLn
where hh:
Shh
where hh:
Lhh
where n:
Rn
where n:
Wn
where n:
En
where xxx:
Pxxx
80
Extended System-Level Command Functions
D = Disable Disables the RFID module. ("N" is also a valid disabler.)
H = HF Enables the RFID module for HF (Securakey).
U = UHF Enables the RFID module for UHF Class 1 (Alien).
M = UHF Enables the RFID module for UHF Multi-Protocol (Samsys).
2-Chararacter Hex ID Sets the Application Family Identifier (AFI), (HF only)
E = Enable,
Allows locking the AFI after writing (HF only)
D = Disable
2-Chararacter Hex ID Sets the Data Storage Format Identifier (DSFID), (HF only)
E = Enable,
Allows locking the DSFID after writing (HF only)
D = Disable
2-Chararacter Hex ID Sets the Electronic Article Surveillance (EAS) set, representing the manufacturer's code. (HF only)
2-Chararacter Hex ID Sets the Lock Code (Alien UHF only)
0 – 9 Sets the number of retries for RFID functions
E = Enable,
Allows locking the tag after writing.
D = Disable
E = Enable,
Allows erasures of the tag on error (HF only)
D = Disable
Sets the tag encoding position: A value of 0.00 causes the print position to be used; or, a value
3-digit value
greater than 0 causes the presented position to be used. (Subject to change.)
Table 5-8: RFID Configuration Set Commands
RFID Configuration Definition / Function
Class Series Programmer's Manual