Datamax A-4310 Programmer's Manual page 89

(NT) Network Setup – This command configures the printer for an Ethernet connection. Each
octet must be zero-filled to be properly interpreted (e.g., an IP Address of 10.12.0.243 must be
sent to the printer as 010.012.000.243).
Value
D
G yyy.yyy.yyy.yyy
I xxx.xxx.xxx.xxx
N xxx.xxx.xxx.xxx
P
S yyy.yyy.yyy.yyy
T
U xxx.xxx.xxx.xxx
w
W xxx.xxx.xxx.xxx
Y xxx.xxx.xxx.xxx
Z xxx.xxx.xxx.xxx
* Prior to the introduction of
Class Series Programmer's Manual
Extended System-Level Command Functions
Parameter
Is Discovery (DHCP or Bootp), where a:
a
Y = Enable
N = Disable
Is the Gateway Address, where:
y = 0 to 9
Is the IP Address, where:
x = 0 to 9
Is the SNMP Trap Address, where:
x = 0 to 9
Is the Port number, where:
xxxx
x = 0 to 9
Is the Subnet Mask, where:
y = 0 to 9
Is SNMP enable,
where a:
a
Y = Enable
N = Disable
Is the WINS2 Address, where:
x = 0 to 9
Is WiFi enable, where a:
a
Y = Enable
N = Disable
Is the WINS1 Address, where:
x = 0 to 9
Is the DNS1 Address, where:
x = 0 to 9
Is the DNS2 Address, where:
x = 0 to 9
WiFi
, 192.0.0.192 was the IP default value and the Subnet Mask was 0.0.0.0.
Table 5-5: Network Setup
Interpretation
*
Default Value
Y
000.000.000.000
192.168.010.026
000.000.000.000
9100
255.255.255.000
Y
000.000.000.000
N
000.000.000.000
000.000.000.000
000.000.000.000
73