Datamax A-4310 Programmer's Manual page 252

GPI/O B (J2)
Six unassigned inputs are designed to interface to open-collector outputs. These inputs require no
external pull-ups and blocking diodes allow the use of totem pole outputs from +4.5 to + 26 VDC. Optical
isolators are available to provide isolation. Two print control interface circuit examples are given below.
For direct inputs:
Use the printer's +5VDC and Ground to supply the devices
interfacing to the GPI/O B inputs (as shown, right).
For electrically-isolated inputs:
To provide galvanic isolation for the GPI/O B inputs, remove
jumper JMP 11 then supply an external +5VDC source
voltage to Pin 1, and remove jumper JMP 10 then supply an
external Ground to Pin 6 (as shown, right).
Six unassigned outputs are programmable and slew-limited. Optional 10K ohm pull-up resistors, one for
each of the output lines, can be used at either +5 or +24 VDC via jumpers JMP 2 – 7.
Note: To avoid damage if external pull-up resistors are used (that is, when Jumpers JMP 2 - 7 are not installed),
ensure that the external voltage does not exceed +30VDC.
The table below details the GPI/O B pin assignments, settings and functions:
Class Series Programmer's Manual
Appendix J – General Purpose Input Output Ports
GPI/O B - J2
13 Input 1
8 Input 2
Input 3
3
Input 4
12
7 Input 5
2 Input 6
Ground
6
+5 VDC External Source
GPI/O B - J2
1 Vcc
Input 1
13
Input 2
8
Input 3
3
Input 4
12
7 Input 5
2 Input 6
6
Ground
236