Datamax A-4310 Programmer's Manual page 253

Failure to properly configure the GPIO Port can result in damage to the printer and / or connected devices.
WARNING
Signal Name / Direction
Pin Number
1 +5 VDC
2 Input 6
3 Input 3
4 Output 6
5 Output 3
6 Ground
7 Input 5
8 Input 2
9 Output 5
10 Output 2
11 +24 VDC
12 Input 4
13 Input 1
14 Output 4
15 Output 1
[1]
Signal directions are given relative to the printer.
Class Series Programmer's Manual
Appendix J – General Purpose Input Output Ports
Applicator Interface Card (Version 2) GPI/O Port B Overview
[1]
Jumper Position
Installed
JMP 11
Removed
N/A N/A
N/A N/A
Installed: Pins 1 – 2
Installed: Pins 2 – 3
JMP 7
Removed
Installed: Pins 1 – 2
JMP 4 Installed: Pins 2 – 3
Removed
Installed
JMP 10
Removed
N/A N/A
N/A N/A
Installed: Pins 1 – 2
JMP 6 Installed: Pins 2 – 3
Removed
Installed: Pins 1 – 2
JMP 3 Installed: Pins 2 – 3
Removed
N/A N/A
N/A N/A
N/A N/A
Installed: Pins 1 – 2
JMP 5 Installed: Pins 2 – 3
Removed
Installed: Pins 1 – 2
JMP 2 Installed: Pins 2 – 3
Removed
Function / Description
Printer +5VDC is used (.5 amp maximum).
Note: Drawing more than .5 amps can cause unreliable printer operation.
+5VDC must be supplied.
Programmed input function.
Programmed input function.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Printer chassis is used.
Ground must be supplied.
Programmed input function.
Programmed input function.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Printer +24 VDC (1.5 amp maximum).
Programmed input function.
Programmed input function.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
237