At The End Of The Program; When The Washing Program Is Completed, But There Is Water In The Drum; Auto Standby Function - Zanussi ZKN71246 User Manual

20 www.zanussi.com

5.9 At The End Of The Program

-
The appliance stops automatically.
-
The acoustic signal will operate.
-
The display will show "
-
The indicator of the touchpad
"Start/Pause
-
The door lock indicator "
-
Remove the laundry from the
appliance. Make sure that the drum is
empty.
-
Keep the door partly open, to prevent
the mildew and odours.
-
Turn off the water tap.
At the end of the program, the time
remaining can suddenly decrease
from 7 minutes or less to 0 due to the
overestimated total program time
during the load sensing phase. In
some cases (with perfectly balanced
load) the program time can be shorter
than the time estimated after the load
sensing phase is completed. This is a
normal behavior of the machine and
not a cause for concern as it does not
compromise its performance.
5.10 When The Washing
Program Is Completed, But
There Is Water In The Drum
(Option "Rinse Hold" is used)
-
The drum turns regularly to prevent
the creases in the laundry.
-
The indicator "Start/Pause
to remind you to drain the water.
-
The door lock indicator "
The door stays locked.
You must drain the water to open the
door.
To drain the water:
Press the "Start/Pause
1.
The appliance drains the water and
spins with the maximum spin speed
for selected program.
Alternatively, before pressing the
"Start/Pause
press the "Spin
change the spin speed. You can
select "No Spin
machine to only drain the water.
".
" goes off.
" goes off.
" flashes
" is on.
" touchpad.
" touchpad, you can
" touchpad to
", if you want the
Press "Start/Pause
program.
When the program is completed and
2.
the door lock indicator "
you can open the door.
turn the program selector knob to the
3.
position "Off" to deactivate the
appliance.
NOTE:
After approximately 18 hours, if you do
not press Start/Pause touchpad, the
appliance will drain and spin automati-
cally (except for "Wool" program) .
5.11

AUTO Standby Function

The AUTO Standby mode automatically
deactivates the appliance to decrease
the energy consumption when:
You do not press any buttons for
5 minutes before you press
"Start/Pause ".
-
All indicators and the display will
switch off.
-
The indicator of the touchpad
"Start/Pause
Press any touchpad to reactivate
the appliance.
5 minutes after the washing program
ends, if you do not deactivate the
appliance, the energy saving function
activates.
-
All indicators and the display will
switch off.
- The indicator of the touchpad
"Start/Pause
Press any touchpad to
reactivate the appliance.
-
Display will show the end of the last
wash.
-
Press any touchpad again to show
the last wash program.
-
Turn the selector knob to set a new
wash program.
" to start the
" goes off,
" will flash slowly.
" will flash slowly.