Settings - Zanussi ZKN71246 User Manual

Vapour Touchpad
Select this option to add approximately
30 minutes of tumbling in vapour during
the wash cycle. Vapour helps open fabric
fibers up to allow laundry additives to
release tough stains. The indicator of this
option will be on.
NOTE:
●
Vapour may not necessarily be visible
inside the drum during a vapour wash
cycle. Vapour is created below the
drum and allowed to naturally rise into
the clothes.
●
Vapour may not be present during the
entire vapour wash cycle.
●
Vapour function is more effective with
half load.
●
At the end of the Vapour cycle, the
clothes will be warmer, softer and
detached from the drum.
If Vapour option is selected, rinse
temperatures will be elevated.
During a vapour cycle, you may
notice vapour exiting from the drain
hose of the washer-dryer, this is
normal and there is no cause for
alarm.

3.6 Settings

Child Safety Lock Option
Your appliance is provided with CHILD
SAFETY LOCK which permits you to
leave the appliance unsupervised with
the door closed without having to worry
that children might be injured by or cause
damage to the appliance.
Set this option after pressing the
"Start/Pause
To set "Child Lock" option:
●
To activate the function, press
"Dry Time and Dryness
touchpads at the same time until the
display shows the symbol "
The touchpads are locked.
●
To deactivate the function, press
"Dry Time and Dryness
touchpads at the same time until the
symbol " " goes off.
This function remains enabled
even after the appliance is
switched off.
Enabling/Disabling End-Of-Wash
Buzzer
This setting permits you to either enable
or disable the buzzer at the end of the
program. As an example, you might wish
to disable this buzzer when you start a
wash when going to bed, so that when the
wash finished approximately 1 hour later,
it will not disturb you through the night.
Error warning beeps such as critical
faults are not disabled.
To disable the buzzer sound, press
"Dryness and Prewash
pads at the same time for 3 seconds,
and listen for "BEEP, BEEP".
To return to default configuration press
these 2 touchpads at the same time for 3
seconds, and listen for "BEEP".
15
ENGLISH
" touchpad.
"
".
"
" touch-