Emergency Door Opening - Zanussi ZKN71246 User Manual

Malfunction
Spinning starts
late or the
machine does
not spin:
The machine
makes an
unusual noise:
The machine
does not dry or
does not dry
properly:
Display time is
frozen at the
end of drying
cycle for more
than 30 minutes:
If you are unable to identify or solve the
problem, contact our service centre.
Before calling service centre, make a note
of the model, serial number and purchase
date of your machine: the Service Centre
will require this information.
Possible Cause
The electronic unbalance detection device has
cut in because the laundry is not evenly
distributed in the drum. The laundry is
redistributed by reverse rotation of the drum.
This may happen several times before the
unbalance disappears and normal spinning
can resume. If, after 10 minutes, the laundry is
still not evenly distributed in the drum, the
machine will not spin. In this case, redistribute
the load manually and select the spin program.
Machine not installed properly.
Transit bolts or packaging not removed.
The load may be too small.
The "Dry Time" or the "Dryness" degree has
not been selected.
The water tap is not turned on. (code:
The drain filter is clogged. (code:
The machine is overloaded.
The selected drying program, time or dryness
degree was not suitable for the laundry.
Machine is optimizing the drying cycle
according to the laundry type and load size. It
will vary for each kind of fabric as the water
absorption is different.
)
)

11.2 Emergency Door Opening

In case of power failure or appliance failure,
the appliance door remains locked. The wash
program continues when power is restored. If
the door remains locked in case of failure, it is
possible to open it using the emergency unlock
feature.
Before Opening The Door:
WARNING!
●
Make sure that the water temperature and
the laundry are not hot. Wait until they
cool down if necessary.
●
Make sure that the drum is not rotating.
Wait until the drum stops rotating if
necessary.
ENGLISH
Solution
Pause the machine and
redistribute laundry
manually.
Make sure the levelling of
the appliance is correct.
Refer to "Installation".
Make sure that the
packaging and/or the
transit bolts are removed.
Refer to "Unpacking".
Add more laundry in the
drum.
Select the drying time or
the dryness degree.
Open the water tap.
Clean the drain filter.
Reduce the laundry load
in the drum.
Select the suitable drying
program, time or dryness
degree for the laundry.
This is a normal behavior
of the machine and not a
cause for concern as it
does not compromise its
performance.
33