Water Inlet; Water Drainage - Zanussi ZKN71246 User Manual

When the washer-dryer is levelled, try to
rock it from corner to corner. If it does
rock, adjust the legs again until it is
levelled and does not rock.
Never place cardboard, wood or similar
materials under the machine to
compensate for any unevenness in the
floor. Install the machine on a flat hard
floor. Make sure that air circulation
around the machine is not impeded by
carpets, rugs etc.
Check that the machine does not touch
the wall or cupboard units.

13.3 Water Inlet

Connect the water inlet hose to a tap
with 3/4" BSP thread.
Use the hose supplied with the washer-
dryer. DO NOT USE OLD HOSES.
check
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase a
new, longer hose specially designed for
this type of use.
Loosen the ring nut to angle the hose to
the left or right depending on the position
of your water tap. Do not place the inlet
hose downwards. After positioning the
inlet hose, be sure to tighten the ring nut
again to prevent leaks.
35°
45°

13.4 Water Drainage

The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
Fitting Hose Guide
1.
Pull apart to
insert hose.
2.
Adjust length to suit
trough.
37
ENGLISH
Hose
bend
Guide
hose
pull hose