Tours; Patterns; Autoscan - Lorex N881 Series User Manual

17 Pan/Tilt/Zoom (PTZ) Cameras
To go to a preset location:
• Under No., select the number of the preset you want to go to, then click

17.5 Tours

Tours will cycle through a set of presets.
To add tours:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click Pan/Tilt/Zoom.
2. The PTZ controls open. Click
3. Click the Tour tab.
4. Under Patrol No., enter the number of the tour you want to create.
5. Under Preset, select a preset you want to add to the tour.
6. Click Add Preset.
7. Repeat steps 5 & 6 to add additional presets to the tour.
To run a tour:
• Under No., select the number of the tour you want to go to, then click

17.6 Patterns

Patterns automatically move the camera according to manually-entered movements.
To add patterns:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click Pan/Tilt/Zoom.
2. The PTZ controls open. Click
3. Click the Pattern tab.
4. Under Pattern, enter the number of the pattern you want to create.
5. Move the camera to the desired starting position, then click Start.
6. Using the on-screen controls, move the camera in any pattern you wish. When finished, click
End.
To run a pattern:
• Under No., select the number of the pattern you want to go to, then click

17.7 AutoScan

An autoscan automatically cycles between a left and right point.
To configure autoscan:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click Pan/Tilt/Zoom.
2. The PTZ controls open. Click
3. Click the Border tab.
4. Move the camera into the desired left position and click Left.
5. Move the camera into the desired right position and click Right.
#LX400113; r. 3.0/56326/56332; en-US
to open advanced PTZ controls, then click
to open advanced PTZ controls, then click
to open advanced PTZ controls, then click
.
.
.
.
.
.
109