Crosswater Berea Robe Hook 11-51 Installation Instructions

Berea Robe Hook

11-51

Pencil

For ease of installation you will need:

● To read the installation instructions completely before

beginning.

● To read all warnings, care, and maintenance information.

Tools You Will Need

Drill

Philips Screwdriver

Level

Before beginning installation, check for any damage

that may have occurred during transport.

Note: Damage claims cannot be made during or

after installation.

Flat Head Screwdriver

Table of Contents

Do you have a question about the Berea Robe Hook 11-51 and is the answer not in the manual?

Page 1 Berea Robe Hook 11-51 Installation Instructions Tools You Will Need Pencil Drill Philips Screwdriver Level Flat Head Screwdriver Before beginning installation, check for any damage For ease of installation you will need: that may have occurred during transport. ● To read the installation instructions completely before Note: Damage claims cannot be made during or beginning.
Page 2 11-51 Installation Instructions Align bracket and mark drill Determine the location of the robe Drill 1/4" holes in marked locations holes in desired location hook. Temporarily place the robe hook on Drive the wall anchors into the Place the mounting bracket over the mounting bracket to check drilled holes with a Phillips the wall anchors.
Page 3 11-51 Cleaning Instructions Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and dry any overspray. This will maintain the finish and avoid water spotting. To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the product. Simichrome Polish®...
Page 4 Post set screw 00309 Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website. For further information contact: Crosswater London, 393 Fortune Blvd., Milford, MA 01757 www.crosswaterlondon.com...