Software Upgrade; Obtaining Documentation - H3C SR8800 IM-FW-II Manual

Manual version: 6PW101-20141219
5.2 Removing the card
Use a Phillips screwdriver to loosen the captive screws at both sides of the card.
1.
Pull the ejector levers at both sides of the card outward to separate it from the backplane, and then
2.
pull the card along the guide rails to remove it from the chassis.
Place the card on an anti-static workbench with the surface-mounted components up. You can also
3.
put it in an anti-static bag.
If you are not going to install a new card, install a filler panel to prevent dust and ensure good
4.
ventilation in the router.
6 Logging in to the card
The card uses an independent operating system. Before you can configure the card, you must log in to
the card by using one of the following methods:
• Log in from the router's CLI through the oap connect command.
Log in through the card's Web interface, console port, Telnet, or SSH.
•
H3C recommends that you log in to the card from the router's CLI the first time you access the card. This
section includes a procedure for logging in from the router's CLI. For more information about other login
methods, see H3C SecBlade II Firewall Cards Configuration Guide.
To log in to the card from the router's CLI, perform the following task in user view:
Task
Log in to the card through OAP.

7 Software upgrade

The card uses independent BootWare and system software images. You must upgrade the card software
separately from the router software. To ensure a successful card upgrade, H3C recommends that you
upgrade the card through the card's console port or management Ethernet port. For more information
about software upgrade of the card, see the release notes that come with the card.

8 Obtaining documentation

To access the most up-to-date H3C product documentation on the World Wide Web
at http://www.h3c.com:
Go to http://www.h3c.com/Technical_Documents, or click Technical Support & Documents >
1.
Technical Documents on the top navigation bar at http://www.h3c.com.
Click Security Products > H3C SecBlade Module to choose the desired product category and
2.
model.
Copyright © 2014 Hangzhou H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.
Command
oap connect slot slot-number
v
BOM: 3123A0CS
Remarks
To return to the CLI interface of the
router, press Ctrl+K.