Table of Contents
Advertisement
It will pop up the notification "Err: No Filament" when the filament is run out during
1)
printing and the printer will stop. See picture (9-6).
And at picture (9-7), if the "Filament "shows red, which indicates "No Filament".
2)
Press the extruder handle, remove the remaining filament before loading the new filament.
3)
When the filament is loaded, please use a tweezers to clean the nozzle. Click on the button
in the lower left corner of Picture (9-8) and then it will enter printing information interface.
If the "Filament" shows green which indicates resuming printing. You can click the left
button to start printing.
Shenzhen Getech Technology Co.,Ltd
（Picture 9-5）
（Picture 9-6）
（Picture 9-7）
49
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the A30 Pro and is the answer not in the manual?