Programming Notes - Clifford GP1000T Owner's Manual

sensor disable
The remote button programmed for this feature will make
the system bypass the sensors for one arming cycle only. On
the next arming cycle, zones 1, 2, and 3 will be reinstated.
clear all remotes
This feature will erase all remote codes from the system
memory. This feature is convenient for erasing any remotes
that have been lost, stolen, or incorrectly programmed into
the system.
After entering this feature press the
remote that is programmed to the system; the siren will
chirp twice to indicate that all remotes have been erased
from memory.

programming notes

Note #1: Adding a new remote in auto-learn configuration
Press the
chirp once.
Immediately press
confirm the new remote has been programmed.
Note #2: Adding a new remote in custom-configuration
For the
two, three, four, or five button remote that you want to con-
trol that feature; the siren will then chirp once.
Immediately transmit the same channel again, the siren will
chirp twice to confirm the remote channel has been pro-
grammed.
28
button of the remote control; the siren will
again; the siren will chirp twice to
channel, transmit the channel of the new
button on a