The security system will ignore the input that was active when the sys-
tem was armed, until the input goes away. 3-seconds later the system
will monitor that input normally. For example, if the protective switch
is active, you will hear four Bypass Notification chirps (the protective
switch is bypassed from the alarm system). Once the protective switch
is reset, then 3-seconds later the system resumes normal monitoring of
this switch.
disarming diagnostics
Extra disarm chirps are the Tamper Alert. If three chirps are heard when
disarming, the system was triggered in your absence. If three chirps are
heard, the LED status indicator will indicate which zone was triggered
(refer to the Arm/Disarm Diagnostic Chart and Table of Zones section).
The system will retain this information in its memory. Refer to the
Multiple Event Total Recall section of this guide.
16