features. To program specific functions to a different button, enter the
function you are programming after the chirp confirmation. Press the
button with which you wish to control that feature; the system will
chirp to confirm that it has learned the new button. Refer to Note #2
in Programming Notes section.
arm/disarm only
The remote control channel programmed into this feature
will arm/disarm the system only.
n n o o t t e e : : When programming a remote control to custom configuration, a
remote button must first be learned to the arm/disarm channel by press-
ing the desired button once (one chirp), then again (two chirps). The
rest of the features in this column can then be learned by pressing the
desired button once. The siren will chirp the same number of times as
the feature row as confirmation.
A remote button can only be learned to one designated feature. That
is, if the lock/unlock button is programmed for armed/disarmed (fea-
ture 1 in column 3), it cannot be programmed for another additional
feature listed in column 3 of the User Selectable Features.
accessory (-) output
The remote channel programmed into this feature will acti-
vate the accessory output. Refer to Note #3 in Programming
Notes section.
silent mode
TM
The remote channel programmed into this feature will
arm/disarm the system, but the siren will not chirp.
remote valet on/off
The remote channel programmed into this feature will make
the system enter/exit valet mode.
© 2 0 0 5 d i re c t e d e l e c t ro n i c s , i n c . a l l r i g h t s re s e r v e d
27