Manual Programming Instructions - Clifford GP1000T Owner's Manual

manual programming instructions

It is a good idea to document changes by taking note of all feature
changes made in programming mode.
To enter the User Selectable Features programming:
1. Ignition on - Turn the ignition to the on/run position or start
the engine.
2. Enter PIN - Your PIN code is noted on the back of this guide.
FOR EXAMPLE: To enter a PIN code of 4301—
3. Hold/Chirp/Release - After entering the PIN code, press and
hold
release the button. You have now entered the feature selec-
tion position of the User Selectable Features grid.
4. Column select - Press and release
times as the desired column. After a pause the siren will
chirp the same number of times as the selected column for
confirmation (e.g. 3-chirps means column 3 of the features
is selected).
5. Feature select - Press and release
times as the desired row. The siren will chirp with each press.
The feature can now be changed using the remote control.
22
Press four times,
then once. This enters the digit 4.
then three times,
then once. This enters the digit 3
and then once. This enters a 0 as there was
not a previous digit entered with
then once,
and then once. This enters the final digit 1.
until a chirp is heard and the LED turns on, then
.
the same number of
the same number of