Ta Ble Of User- Selectable Fea Tures - Clifford Concept 600UK How To Use Manual

Dei clifford concept 600uk car alarms: user guide

Hide thumbs

Table of Contents

1 unmarked press

Feature Select

press

Add a master remote

presses

AutoLock: off/instant/RPM-

dependent (1/2/3 chirps)

presses

Reset all features (except remotes

and valet code) to factory settings

NOTE 1: Press button 1 of the new MASTER 16-channel remote control. You will hear

one chirp. Press button 1 again. You'll hear two chirps to confirm the new remote control

has been added.

NOTE 2: You'll hear two chirps to indicate all remotes have been cleared from memory.

You must now add new/existing remotes with the "Add a new master remote" feature

and/or the "Add a companion remote" feature.

NOTE 3: Immediately press the unmarked button, enter your new code, wait for the two

chirps, then turn off the ignition (you'll hear 3 chirps to confirm program mode exit). You

MUST now turn the ignition back on and then re-enter your new code. If the LED flashes

on, your new code has been accepted. If the LED does not light, the two codes did not

match and the system has reverted to your previous code.

Ta ble of User- Selectable Fea tures

2 unmarked presses

Chirps: off/loud/quiet

NOTE 1

(1/2/3 chirps)

NOT USED

Remote valet mode via channel 9

NOT USED

and buttons

AutoStart**: both off/both on/temp

NOT USED

only/battery only (1/2/3/4 chirps)

BlackJax anti-carjacking: off/on

Clear all remotes

AutoUnlock: off/on

NOTE 2

Set a new secret

valet/disarming code NOTE 3

3 unmarked presses

AutoArming: off/on

Lock upon AutoArming: off/on

NOT USED

and

: off/on

FACT: off/on

NOT USED

* Re quires an op tional ac ces sory: ask your Author ised Clif ford Dealer about this fea ture.

** Re quires the op tional Clif ford In tel liS tart 4 ac ces sory not evaluated by Thatcham

NOTE 4: This allows you to arm/disarm your system with a new companion remote or any

remote control of a Concept 100, 300, 400 or 600 system on your other vehicle(s). For

instance, to set channel 13 of the other car's master remote to arm/disarm your Concept

600, select column 4, row 1, then transmit channel 13 (you'll hear one chirp). Immediately

reselect channel 13 on the remote and transmit it a second time (you will hear a 2-chirp

confirmation). Channel 13 of the other car's remote will now arm/disarm your Concept 600.

NOTE 5: The features in this column allow you to control your Concept 600 with a new

companion remote or any remote control of a Concept 100, 300, 400 or 600 system on

your other vehicle(s). Just select the function you wish, then transmit the unused channel

on the other remote that you want to use to perform that function (you'll hear the chirps

noted). NOTE: You must first set a channel on the remote that will arm/disarm the system

(column 4, row 1) before these others will be accepted.

4 unmarked presses

NOTE 4 — Add a companion remote:

arm/disarm (1 then 2 chirps)