Installation And Operation; Installation - Bartscher 5200 2ER Instruction Manual

5. Installation and operation

5.1 Installation

Positioning

Unpack the device and remove and dispose of all package materials according to
the environment protection regulations.

Put the device on an even, stable, dry and waterproof surface which is resistant to
high temperature.

Never place the device on an inflammable surface.

Never place the device at the edge of a table to avoid tilting or falling.

Never put the device in a moist or wet area.

Do not place the device near open flame, electric heaters or other heat source.

When locating the device, make sure the power plug is easily accesible to
immediately unplug the device, if necessary.

Before starting operation, remove the protective film from the device. Remove the
film slowly in order not to leave the glue residues. Any glue residues may be
removed with use of a suitable solvent.
CAUTION!
Never remove the nameplate and warning signs from the device.
- 34 -