Installation And Operation; Installation - Bartscher TA720 Manual

5. Installation and operation

5.1 Installation

Positioning

Unpack the device, remove and dispose of all package material according to
the environment protection regulations.
CAUTION!
Never remove the nameplate and warning signs from the device.

Put the device on an even, stable, dry and waterproof surface which is resistant to
high temperature.

Never place the device on an inflammable surface.

Do not place the device near open flame, electric heaters or other heat source.

Never place the device at the edge of a table to avoid tilting or falling.

Never put the device in a moist or wet area.

Always keep the working area around the device clean and dry.

Never dry towels on the device. This may disturb an internal air circulation and result
in damaging the device due to overheating.

When locating the device, make sure the power plug is easily accessible to
immediately unplug the device, if necessary.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!

The power supply circuit with the socket must be protected by the fuse of at least 16A.
Connect the device directly to a single grounded socket. Do not use any power bar or
multiple socket.
- 28 -