Installation; Installation Location; Climate Class - Miele K 2602 Vi Operator And Maintenance Manual

Installation

Installation location

This appliance should be installed in a
dry, well-ventilated room.
When deciding where to install your
refrigeration appliance, please bear in
mind that it will use more energy if
installed near to a heater, a range, or
another appliance that gives off heat.
Direct sunlight should also be avoided.
The higher the room temperature, the
longer the compressor runs and the
higher the energy consumption of the
refrigeration appliance.
When installing the refrigeration
appliance, please note the following:
- The electrical socket must be easily
accessible in an emergency and not
concealed behind the appliance.
- The plug and power cord must not
touch the rear of the refrigeration
appliance as they could be damaged
by vibrations from the appliance.
- Do not plug in other appliances
behind the refrigeration appliance.
14
If installation near a heat source is
unavoidable, observe the following
minimum distances between the
appliance and the heat source:
- At least 1 1/4" (3 cm)
to electric or gas stoves
- At least 11 3/4" (30 cm)
to oil or coal-based stoves
If it is not possible to observe these
minimum distances, an isolation plate
must be installed between the
refrigeration appliance and the heat
source.

Climate class

The refrigeration appliance is designed
for use within the climate class (room
temperature range) SN-T. Do not use in
a climate class for which it is not
designed.
Climate class
SN
N
ST
T
A lower room temperature will cause
the compressor to switch off for longer
periods. This can cause the internal
temperature in the refrigeration
appliance to rise with the risk of food
deteriorating and going off.
Room
temperature
50°F to 90°F /
10°C to 32°C
60°F to 90°F /
+16°C to +32°C
60°F to 100°F /
+16 to +38°C
60°F to 109°F /
+16 to +43°C