Miele H 7464 BP Operating And Installation Instructions page 109

Problem
The browning of baked
goods is uneven.
There is still soiling in
the oven compartment
after a pyrolytic
cleaning programme.
The accessories make
noises when being
pushed into or pulled
out of the oven.
The oven lighting
switches off after a
short time.
The oven lighting is off
or does not switch on.
Possible cause and remedy
The wrong temperature or shelf level was selected.
 There will always be a slight unevenness in
browning. If browning is very uneven, check
whether the correct temperature and shelf level
were selected.
The material or colour of the baking tin is not suitable
for the oven function.
 When using the
light coloured, shiny tins are not as suitable. Dark,
matte tins are best for baking.
The pyrolytic cleaning programme burns off soiling in
the oven and leaves it as ash.
 Remove the ash using a damp microfibre cloth or
a clean sponge and a solution of hot water and
washing-up liquid.
If there is still coarse soiling left in the oven after
the pyrolytic cleaning programme, you should start
the programme again, selecting a longer duration if
necessary.
The pyrolytic resistant surface of the shelf runners
creates friction when accessories are being pushed
into or pulled out of the oven.
 To reduce the friction, add a few drops of heat-
resistant cooking oil to some paper towels and use
this to lubricate the shelf runners. Repeat this after
every pyrolytic cleaning programme.
You have selected the
setting.
 If you want the oven lighting to remain switched on
during the entire cooking programme, select
the Lighting | On
You have selected the
 Select the  sensor control to switch on the oven
interior lighting for 15 seconds.
 If required, select the
seconds setting.
The oven interior lighting is faulty.
 Call Miele.
Problem solving guide
Conventional Heat
Lighting | On for 15 seconds
setting.
| setting.
Lighting Off
Lighting | On
 function,
or On for 15
109