Panic Mode; Valet Mode - Directed Electronics Failsafe 103T Owner's Manual

If an error is made during the PIN code entry, simply press
to cancel and start over. If the PIN code is not entered correctly
after three tries, your system's trigger sequence will begin.

Panic Mode

To enter Panic Mode from the keypad:
1. Press .
2. Press (labeled PANIC on the keypad).
To stop Panic Mode at any time, repeat the above Panic Mode key-
pad sequence.

Valet Mode

To activate Valet Mode of the ESP system:
1. Enter your personalized PIN code, followed by
2. Within 5 seconds, press
3. Press (labeled VALET on the keypad). The system has
now entered Valet Mode.
The same Valet Mode keypad sequence is used to deactivate Valet Mode.
NOTE: If an incorrect sequence of buttons is pressed while attempting to
exit Valet Mode, the system will ignore any new attempts to exit Valet
Mode for 5 seconds.
The LED will remain lit when the unit is in Valet Mode and the igni-
tion is off. As a power-saving feature, the LED will turn off after 60
minutes and will come back on each time the ignition is cycled.
When the ignition is on, the LED will automatically turn off.
2000 Directed Electronics, Inc.
©
.
.
9