Quick Reference Guide (Removable) - Directed Electronics Failsafe 103T Owner's Manual

QUICK REFERENCE GUIDE
To illuminate the keypad:
Pressing any button will illuminate the keypad.
To program a new, personalized PIN code:
1. Make sure the system is disarmed or in Valet Mode.
2. Turn on the ignition.
3. Enter the existing PIN code and the press
EXAMPLE: To enter an existing PIN code of 1234:
Press
Press
Press
Press
Press
To disarm:
1. Enter your personalized PIN code followed by
To enter or exit Panic Mode:
1. Press .
2. Press (labeled PANIC on the keypad).
NOTE: When using the 103T as a stand-alone starter kill, the optional horn
honk feature must be installed in order for Panic Mode to work.
To activate or deactivate Valet Mode:
When using 103T as stand-alone starter kill:
1. Make sure that the system is disarmed.
2. Press .
3. Press (labeled VALET on the keypad). The system has now entered
Valet Mode.
When using 103T as an ESP interface:
1. Enter your personalized PIN code, followed by
2. Within 5 seconds, press
3. Press (labeled VALET on the keypad).The system has now entered Valet Mode.
NOTE: If an incorrect sequence of buttons is pressed while attempting to exit Valet
Mode, the system will ignore any new attempts to exit Valet Mode for 5 seconds.
To arm:
1. Press .
2. Press (labeled on the keypad).
NOTE: When using the 103T as a serial interface for a DEI ESP system,
this feature may not currently be available. Please consult the Security
and Convenience Expansions section of your ESP model owner's guide
to determine if this feature is compatible with your system.
2000 Directed Electronics, Inc.
©
for 1.
for 2.
for 3.
for 4.
to enter the code.
.
. The LED will flash once.
.
.
11