Fisher & Paykel DOUBLE DISHDRAWER DD60DA Installation Manual page 11

!0 A
- SECURE TO THE CABINETRY ON THE SIDES
Open the drawer
halfway. Using
a flat bladed
screwdriver, prise
the grey rubber
plug out of the
trim moulding.
2
Using a small Philips
screwdriver, screw
through the trim
moulding, securing the
side mounting bracket
to the cabinetry.
Do not damage the
rubber trimseal.
!2 A
- AFTER SECURING, DEPENDING ON YOUR MODEL - REFER TO RELEVANT 'FIT THE SUPPLIED TOEKICK PANEL' STEP
1
Replace the grey
rubber plug back into
the trim moulding
and ensure the trim
seal is facing forward.
3
Repeat for all
four brackets.
!1 A
- OPTIONALLY SECURE TO THE CABINETRY ABOVE
The top mounting
brackets will only
bend upwards a
(x2)
maximum of 10 mm.
9