Fisher & Paykel DOUBLE DISHDRAWER DD60DA Installation Manual page 13

!0 B
- SECURE TO THE CABINETRY ON THE SIDES
For further adjustment,
using the most appropriate
length Hexagonal socket
supplied, fully extend
levelling feet up to
required distance by hand.
Hexagonal
x4 socket
2
Before refitting the
drawer, ensure the hoses
are not twisted and the
latches at the rear of
each drawer runner are
facing forward.
!3 B
- AFTER SECURING, DEPENDING ON YOUR MODEL - REFER TO RELEVANT 'FIT THE SUPPLIED TOEKICK PANEL' STEP
Secure using two pairs
of formed brackets.
Repeat on the other
side of the chassis.
Ensure product is level and
aligning with cabinetry.
!2 B
- REFIT THE DRAWER ONTO THE RUNNERS
1
!1 B
- OPTIONALLY SECURE TO THE CABINETRY ABOVE
Lift or rotate anti-clockwise the
drawer back onto the drawer runners
on either side.
3
Release tab
The top mounting
brackets will only
(x2)
bend upwards a
maximum of 10 mm.
4
Pull the release tabs forward on both
sides 100 mm. Ensure the tabs are fully
pulled forward and click into place.
11