Fisher & Paykel DOUBLE DISHDRAWER DD60DA Installation Manual page 14

min.2 mm
clearance
HEIGHT OF
TOEKICK
min.12 mm
clearance
115 mm
Measure how high the toekick should
be based on min. 12 mm clearance to
floor and the table below.
HEIGHT FROM FLOOR TO NUMBER OF CUTOFF SECTIONS
BOTTOM OF DOOR (MM) TO REMOVE FROM PANEL
100-114
115-129
130-144
145-160
if after fitting, the drawer touches the floor with a full load, you need to remove more of the toekick panel:
A
Remove the lower drawer (see ALTERNATIVE METHOD (B) - SECURE BY DRAWER REMOVAL - STEP 8 B: REMOVE THE LOWER DRAWER)
B
Remove the pins - use a pair of needle nose pliers to press the pin legs together and push back through the hole
C
Remove the panel, and cut off another section of the kick strip following steps 2-8 above.
D
Replace the drawer (see ALTERNATIVE METHOD (B) - SECURE BY DRAWER REMOVAL - STEP 11 B REFIT THE DRAWER ONTO THE RUNNERS)
E
Continue from step 7 above.
12
!4
FIT THE SUPPLIED TOEKICK PANEL - DD60DA MODELS ONLY
2
1
On a board, lay the toekick on its
side and carefully score/cut down the
Cutoff Sections
corner to where the cutoff will be.
There are 3 preset height positions.
Carefully bend and snap off the side.
Repeat in the opposite corner.
Using a hammer and screwdriver,
punch out the two mounting hole
locations as shown.
Repeat on the opposite side.
3
2
1
0
Once the sides are removed, score/cut all the
way down the middle of the toekick.
3
Use a file to smooth the top edges.
5
6
5
Mount the toekick into position over the
cowling. Ensure the holes in the toekick
match up with the mounting hole positions
on the cowling. Push the two pins in to
secure. Repeat on the opposite side.
Carefully bend and snap off.
4
7
8