Table of Contents
Advertisement
DWL-8220AP User's Manual
Suspended Ceiling Installation—Drop Ceiling Tiles
1. Select an installation location that is centered over a T-bar in the ceiling.
2. Cut a hole as follows in the ceiling tile for the CAT5 cable(s):
a. Place the mounting template over the area where you plan to install the access
point.
b. Use the box cutter to cut along the line marking the opening for the port
connectors.
c. Remove the mounting template and the material you cut from the ceiling panel.
3. Install the T-bar clamp that fits the T-bar:
a. Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the
T-bar.
b. Slide the two halves of the clamp toward each other until the tabs are inserted
completely into the holes and the clamp fits snugly on the T-bar.
4. Unlock the universal mounting bracket from the access point by inserting the 3-mm or
1/8-inch screwdriver into the Unlock hole on the access point as shown below.
Note: To avoid damage to the access point's lock mechanism or electronic components, do
not use excessive force when inserting a tool into the Unlock or Lock hole.
D-Link Systems, Inc.
Installation (continued)
Installation
17
Advertisement
Table of Contents
