D-Link DWL-8220AP Manual page 23

Wireless switch access point

Hide thumbs Also See for DWL-8220AP:

Table of Contents

DWL-8220AP User's Manual

4. Remove the bracket as shown below.

5. Feed the CAT5 cable(s) through the port connector opening and align the universal

mounting bracket over the drywall anchors so that the two screw holes in the bracket face

the drywall anchors.

6. Insert the #6 sheet metal screws into the screw holes, and tighten them to secure the

universal mounting bracket to the wall or ceiling. If you routed the CAT5 cable through a hole

in the wall or ceiling, insert the screw into the center screw hole only.

Note: Do not insert screws in the four holes on the edges of the bracket. The access point

ﬁts into these holes. They are not screw holes.

D-Link Systems, Inc.

Installation (continued)

Installation

Table of Contents