Installation; Suspended Ceiling Installation-Flush Ceiling Tiles - D-Link DWL-8220AP Manual

Wireless switch access point

Hide thumbs Also See for DWL-8220AP:

Table of Contents

DWL-8220AP User's Manual

Suspended Ceiling Installation—Flush Ceiling Tiles

1. Select an installation location that is centered over a T-bar in the ceiling.

2. Cut a hole as follows in the ceiling tile for the CAT5 cable(s):

a. Place the mounting template over the area where you plan to install the AP.

b. Use the box cutter to cut along the line marking the opening for the port

connectors.

c. Remove the mounting template and the material you cut from the ceiling panel.

3. Determine whether to install a T-bar clamp onto the ceiling T-bar:

• If the T-bar width is 14.2 mm (9/16 inches), you need to install the 14.2-mm (9/16

inch) T-bar clamp. Go to step 4.

• If the T-bar width is 23.9 mm (15/16 inches), the universal mounting bracket ﬁts

directly onto the T-bar. Go to step 5.

4. Install the 14.2-mm (9/16-inch) T-bar clamp onto the ceiling T-bar as shown below.

a. Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the

T-bar.

b. Slide the two halves of the clamp toward each other until the tabs are inserted

completely into the holes and the clamp ﬁts snugly on the T-bar.

5. Unlock the universal mounting bracket from the AP by inserting the 3-mm or 1/8-inch

screwdriver into the Unlock hole on the AP.

D-Link Systems, Inc.

Installation

Table of Contents