Cable Requirement; Suspended Ceiling Installation - D-Link DWL-8220AP Install Manual

Wireless switch access point

Hide thumbs Also See for DWL-8220AP:

Table of Contents

DWL-8220AP Install Guide

Installing the Hardware

Cable Requirement

The Ethernet ports on the DWL-8220AP access point cannot

accept a CAT 5 cable that has an uneven sheath such as the

one shown below. The RJ-45 connector on the cable will not seat

properly in the receptacle on the access point. Use a CAT 5 cable

with an even sheath instead.

Flush Ceiling Tiles

This procedure applies to T-bars that are 23.9 mm (15/16 inches)

wide.

DWL-8220AP

Mounting Template

Mounting Bracket

1. Use the mounting template to cut a hole for the CAT 5 cable.

D-Link Systems, Inc.

Table of Contents