Table of Contents
Advertisement
DWL-8220AP User's Manual
11. Lock the access point onto the bracket by inserting the 3-mm or 1/8-inch screwdriver into
the Lock hole on the access point as shown below.
12. To ensure that the access point is fully locked onto the bracket, gently pull down on the
access point and attempt to rotate it from side to side.
13. If the access point comes off the bracket, relock the device onto the bracket as described
in step 11.
14. If the access point requires an external antenna, install and connect the antenna.
15. If the other ends of the CAT5 cable(s) are not already connected and the link activated,
go to "Connecting an AP to a DWS-1008 Wireless Switch" on page 27. Otherwise, go to
"Verifying AP Health" on page 28.
D-Link Systems, Inc.
Installation (continued)
Installation
20
Advertisement
Table of Contents
