Table of Contents
Advertisement
DWL-8220AP User's Manual
6. Remove the bracket as shown below.
7. Install the universal mounting bracket as follows onto the T-bar or T-bar clamp:
a. As shown below, place the universal mounting bracket against the T-bar or clamp
so that the two screw holes face downward and the two T-bar flanges face upward
and are adjacent to the T-bar edges.
b. Properly align the bracket for mounting by placing the bracket so that its port
connector opening is to the left of the hole you cut for the cables.
c. Rotate the universal mounting bracket clockwise until the flanges snap into place
on the T-bar or clamp as shown.
D-Link Systems, Inc.
Installation (continued)
Installation
14
Advertisement
Table of Contents
