Table of Contents
Advertisement
DWL-8220AP User's Manual
8. Pull the CAT5 cable(s) about 15 cm (about 6 inches) out of the hole in the ceiling tile and
through the port connector opening to create enough slack to insert the cable(s).
9. Insert the CAT5 cable(s) into the connector(s):
• For a single connection, use the connector for port 1.
• For redundancy, insert one cable into each connector.
10. Install the Kensington lock, if you plan to used one.
a. Loop the Kensington lock's cable around an object that cannot be moved or
damaged by a person pulling on the cable.
b. Insert the key into the Kensington lock.
c. Insert the Kensington lock into the security slot on the AP.
d. Rotate the key right or left to secure the lock to the AP.
e. Pull on the lock to verify that it is secured to the AP.
f. Remove the key.
11. Lift the access point into place on the universal mounting bracket as shown below. Make
sure the cable feeds properly into the ceiling as you lift the device, and does not become
trapped between the access point and the bracket.
12. Lock the access point onto the bracket by inserting the 3-mm or 1/8-inch screwdriver into
the Lock hole on the access point as shown below.
D-Link Systems, Inc.
Installation (continued)
Installation
15
Advertisement
Table of Contents
