Technical Data; Input / Output Connector Pin Assignments - Nordson EFD Liquidyn V10D Operating Manual

Liquidyn V10D Controller

Technical Data

Input / Output Connector Pin Assignments

• All inputs and outputs are electrically separated.
• The controller is actuated by a 24V I/O signal at the Remote input. The
controller reacts to every square-shaped pulse (raising edge at least 2 ms.)
• Refer to "Use the Push-Button Board to Test the Controller Operation" on
page 18 to test the Remote I/O using the push-button board.
Pin Direction
1 Output
2 NC
3 Input
4 Input
5 Input
6 Input
7 Input
8 Input
9 Input
10 Output
11 Output
12 Output
13 Output
14 NC
15 Input
16 Input
17 Input
18 Input
19 Input
20 Input
21 Input
22 Output
23 Output
24 Output
25 NC
20 www.nordsonefd.com info@nordsonefd.com
Assignment Description
+24 VDC Out; Operating voltage
max. 0.25 A
Not assigned
+ START1 Starts Program 1
+ STOP Stops
+ SINGLE SHOT Single shot mode, valve
+ RESET Counter / reset steps
+ START2 Starts Program 2
+ START3 Starts Program 3
+ START4 Starts Program 4
+ BUSY Busy
+ ERROR Error notice (ON = No error)
+ COUNTER Counter
- 24V (GND) Out Operating voltage
Not assigned
- START1
- STOP
- SINGLE
- RESET
- START2
- START3
- START4
- BUSY
- ERROR
- COUNTER
Not assigned
800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
1 14
13 25