Table of Contents
Advertisement
Setup (continued)
View or Change Parameters
1.
Open the V10 Digital Software.
2.
Select the desired language: English or German.
3.
Select the COM Port to which USB-to-RS 232 adapter cable is connected.
NOTE: If you cannot determine the COM port, refer to "Setting Up the COM Port" below.
4.
Click SHOW CURRENT VALUES.
5.
Observe the current settings under the CURRENT VALUES column.
6.
Enter changes under the NEW VALUES column. Refer to "About the V10D Controller Parameters" on page 16
for information about parameters.
7.
Click ENTER NEW VALUES to save the changes.
NOTE: The controller can store 4 programs, each with different parameter settings.
8.
When programming is complete, disconnect the USB-to-RS 232 adapter cable from the controller.
Setting Up the COM Port
If it is unclear which COM-Port should be chosen, proceed as follows:
1.
Enter the Windows system control (Start -> System control).
2.
Select Hardware and Sound.
3.
Open Devices and Printers > Device Manager.
4.
Open Inputs (COM & LPT). It should read "Prolific USB-to-Serial Com Port" and in brackets "COM" with a
number. Select this COM port.
www.nordsonefd.com info@nordsonefd.com
3
4
800-556-3484
Sales and service of Nordson EFD dispensing systems are available worldwide.
5
6
Liquidyn V10D Controller
2
7
15
Advertisement
Table of Contents
