Kogan KAGFLWASH8A Owner's Manual page 17

Problem
Error Code
The machine "E01" is on the
fills overtime. screen.
There is a Door "E02" is on the
lock alarm. screen.
The machine "E03" is on the
drains overtime. screen.
Water overflows
the machine. "E04" is on the
/ Water sensor screen.
works abnormal.
The motor does "E05" is on the
not work.
screen.
There is a
"E06" is on the
heating tube
screen.
fault.
There is a
"E07" is on the
temperature
screen.
sensor fault.
Possible Cause
1. The water tap is not open.
2. The drain hose is put down.
3. The water inlet valve is damaged.
1. The door is not locked well.
2. garment is caught between the
door and the seal.
3. The door lock is damaged.
1. The drain hose is squashed
or kinked.
2. The drain pump filter is block.
3. The drainage system pipes
are blocked.
1. The water inlet valve is damaged.
2. The connection between the
water sensor and wire is not
secure.
3. The water sensor is damaged.
1. The connection between the
motor and wire is not secure.
2. The motor is protected because
of over-heat.
3. The motor is damaged.
1. The connection between the
heating tube and wire is not
secure.
2. The heating tube is damaged.
1. The connection between the
temperature sensor and wire is
not secure.
2. The temperature sensor is damaged.
1. Open the water tap.
2. hook up the hose.
3. Change the water inlet valve.
1. Lock the door well.
2. Put the garment into the drum.
3. Change the door lock.
1. Check the drain hose.
2. Clean the filter.
3. Check the drainage system
and clean it.
1. Change the water inlet.
2. Check the connection and ensure
it is secure.
3. Change the water sensor.
1. Check the connection and ensure
it is secure.
2. Check if the machine is overloaded.
Switch off the machine, and retry
when the motor becomes cool.
3. Change the motor.
1. Check the connection and ensure
it is secure.
2. Change the heating tube.
1. Check the connection and ensure
it is secure.
2. Change the temperature sensor.