Tilt Lever - Suzuki DF70A Owner's Manual

TILT LEVER

The Tilt Lever is provided so you can support
the motor in a tilted position for non-moving
engine support.
To set the Tilt Lever:
1. Tilt the motor all the way up using the Power
Trim and Tilt.
2. Pull down the Tilt Lever as shown in the illus-
tration.
3. Lower the motor using the Power Trim and
Tilt, until the motor is supported by the Tilt
Lever.
To release the Lever, tilt the motor all the way
up using the Power Trim and Tilt, and pull up
the Tilt Lever.
 CAUTION
The remote Power Trim and Tilt switch
will work when the ignition switch is off.
If someone activates the switch while you
are moving the tilt lever, your hand could
be injured.
Keep all persons away from the remote
Power Trim and Tilt switch while you are
moving the tilt lever.
26
NOTICE
Damage can occur if you use the tilt lever
other than when the boat is moored or is
otherwise stationary.
The tilt lever relieves pressure from the
power trim and tilt and should only be
used when the boat is stationary. Do not
use the tilt lever when trailering your boat
and motor. Refer to the TRAILERING sec-
tion of this manual.