Table of Contents
Advertisement
Hardware Integration Guide
Poor routing
The yellow traces cross the RF trace.
Figure 2.
RF Routing Examples
Fill the area around the RF traces with ground and ground vias to connect inner ground layers
for isolation.
Cut out ground fill under RF signal pads to reduce stray capacitance losses.
Avoid routing RF traces with sharp corners. A smooth radius is recommended.
E.g. Use of 45° angles instead of 90° .
The ground reference plane should be a solid continuous plane under the trace.
The coplanar clearance (G, below) from the trace to the ground should be at least the trace
width (W) and at least twice the height (H). This reduces the parasitic capacitance, which
potentially alters the trace impedance and increases the losses.
E.g. If W = 100 microns then G = 200 microns in an ideal setup. G = 150 microns would also
be acceptable is space is limited.
Figure 3.
Coplanar Clearance Example
Note:
The figure above shows several internal ground layers cut out, which may not be necessary for
every application.
41110461XXXX
Correct routing
There is no signal around the RF path.
Rev 0.12
Routing Constraints and Recommendations
January 16, 2017
22
Advertisement
Table of Contents
