Replacing The V - Belt - Stihl TS 700 Instruction Manual

English
Checking the Spark Plug
Clean dirty spark plug.
N
Check electrode gap (A) and
N
readjust if necessary – see
"Specifications".
Rectify the problems which have
N
caused fouling of the spark plug.
Possible causes are:
Too much oil in fuel mix.
–
Dirty air filter.
–
Unfavorable running conditions.
–
WARNING
Arcing may occur if the adapter nut (1) is
loose or missing. Working in an easily
combustible or explosive atmosphere
may cause a fire or an explosion. This
can result result in serious injuries or
damage to property.
34
Use resistor type spark plugs with a
N
properly tightened adapter nut.
Installing the spark plug
Fit the spark plug by hand and
N
screw it in
Tighten spark plug with combination
N
wrench
A
Press the spark plug boot firmly
N
onto the spark plug
Position the cap for the spark plug
N
boot and screw it down
1

Replacing the V - belt

4
2
6
1
5
6
6
The arrow on the tensioning nut (1)
N
must point to 0 – to this end, turn the
tensioning nut (1) with the
combination wrench
counterclockwise –
approx. 1/4 turn, as far as
possible = 0
Unscrew the nuts (2) from the studs
N
Remove the V-belt guard (3) and
N
remove the V-belt from the front
pulley
Remove the "support with guard".
N
Remove the hose (4) from the guide
N
of the starter cover (5)
Remove the screws (6) from the
N
starter cover
Remove the starter cover
N
Remove the defective V-belt from
N
the cast arm
TS 700, TS 800
3