Stihl TS 700 Instruction Manual page 24

English
Removing the V-belt guard
4
3
2
1
Pull the V-belt guard (1) off and
N
remove the V-belt (2) from the front
pulley (3)
Remove the "support and guard" (4)
N
Preparing the "support with guard" for
outboard mounting
2
1
Unscrew the stop pin (1)
N
Remove the sealing plug (2)
N
22
2
1
3
Turn the guard so that it is in the
N
position shown (see picture)
Screw in and tighten the stop pin (1)
N
Insert the sealing plug (2)
N
Move the adjusting lever (3) to
N
position A
Insert and tighten the screw (4)
N
5
2
Turn the "support with guard" so
N
that the guard is on the outboard
side
Insert the square nut into the guide
N
in the guard and hold it in place
Screw in the shorter banjo bolt (5)
N
and washer at the adjusting lever
and tighten up with the combination
wrench
Insert the sealing plug (2)
N
Insert and tighten the screw (4)
N
Mounting "support with guard" – guard
on the outboard side
4
A
4
Fit the "support with guard" (1) on
N
the outboard side of the cast arm -
at the same time, guide the V-belt
over the belt pulley
NOTICE
The belt action must run smoothly.
Position the V-belt guard (2)
N
Align studs (3) in support with
N
nuts (4) in the V-belt guard
Screw nuts (4) onto studs (3) – do
N
not tighten them yet
1
3
2
4
TS 700, TS 800