Advertisement
5000-022A ASSEMBLY INSTRUCTIONS
Step 7: Install the Roller Arm Mount Tube inside the clamp channel of the pivot arms using the 5000-
138 bolt bag. Do not tighten this hardware until after the rollers have been installed in Step 8.
Step 8: Insert the shim washer over the shaft on each end of the roller. Install the bearing over the shaft
on each end of the roller so that the side of the casting that has the bearing protruding past the housing
surface is towards the roller barrel & shim washer. Lift each roller into place so that the bolt holes on the
cast housing of the bearing line up with the holes on the mounting tabs on the roller arm mount tube. Install
the ½" X 2 ½" bolts & tighten the ½" lock nuts. Once the roller & bearing hardware is fastened, spin the
roller to ensure the bearing was installed correctly. If the roller was installed incorrectly, the roller will not
spin or will have drag. Slide the roller mount tube to gain clearance on each end of the corn head & then
tighten the hardware from Step 7. The traction bars DO NOT have to be directly centered under the row.
14
Advertisement
