Table of Contents
Advertisement
Stop operation and remove unit from
window in severe storm or hurricane.
• Operation during a severe storm may allow
a significant amount of water to enter the
indoors.
Do not place obstacles around air-intake
vents or inside cool air outlet.
• It may cause failure of appliance.
Do not use strong detergent such as
wax or paint thinner to clean the unit.
Use a damp, soft cloth.
• Appearance may deteriorate due to change
of product color or scratching of its surface.
ELECTRICAL SAFETY
CAUTION
• Be sure your electrical wiring is adequate for the model you have chosen. This information can be found on
the rating label, a silver-colored sticker generally located on the right side of the cabinet.
• Be sure the air conditioner is properly grounded. To minimize shock and fire hazards, proper grounding is
important. The power cord is equipped with a three-prong
grounding plug for protection against shock hazards.
• Your air conditioner must be connected to a properly ground-
ed wall receptacle. If the wall receptacle you intend to use
is not adequately grounded or protected by a time delay
fuse or circuit breaker, have a qualified electrician install the proper
receptacle.
• Ensure the receptacle is accessible after the unit installation.
The power supply cord contains a current device that senses damage
to the power cord and excess current draw from the unit. To test your
current device do the following:
1.
Plug in the Air Conditioner.
2.
Press the TEST button. You will hear a click as the RESET button
pops out within the rubber housing and the LED will turn off.
3.
Press the RESET button. You will hear a click as the button
engages and the LED will illuminate.
4.
The power supply cord is now supplying electricity to the unit.
Note: Your model may have the TEST and RESET buttons on the
side or the front of the plug head.
NOTES:
• Do not use the TEST and RESET buttons to turn the unit on or off.
• If the current device fails the test or the power cord becomes dam-
aged, the entire power cord must be replaced with an equivalent
power cord and current device by a licensed electrician.
CAUTION
Hold the plug by the head of the power
plug when unplugging unit.
• Pulling from the wire can cause wire to fray
leading to electric shock or fire.
If unit is equipped with an outdoor
installation bracket, periodically ensure that
it has not become damaged.
• If bracket is damaged, the unit can fall and
cause damage, personal injury or death.
Do not place heavy objects on the
power cord and ensure that the cord
is not pinched or stressed.
• There is danger of fire or electric shock.
–5–
Unplug the power cord when not using
the unit for extended periods of time.
• Will prevent damage to the unit.
Always insert the filters securely.
Clean filter at least once per month.
• Operation with dirty filters (or without
filters) will effect performance and may
cause damage to the unit.
Do not place this window-type air
conditioner through a wall.
• This will block the side vents and pre -
vent the unit from cooling properly.
NOTE:
The power supply cord with this air conditioner
contains a current detection device designed to reduce the risk
of fire. In the event that the power supply cord is damaged, it
cannot be repaired -- it must be replaced with a cord from the
Product Manufacturer.
Side button
version
Advertisement
Table of Contents
