Table of Contents
Advertisement
87076_1.book Page 35 Monday, March 10, 2008 9:21 AM
Chapter 3: Commissioning & Setup
Setup map
Enter
DEALER
CALIBRATION
No
Rudder ref
fitted
Entering Dealer calibration
Enter Dealer calibration as follows:
1. Ensure the SPX-5 Sport system is in Standby mode.
2. Hold down standby for two seconds to enter the Calibration mode.
At the CAL ? screen, press
3. When the screen shows DISPLAY CAL, press disp until the DEALER CAL screen
is displayed.
4. Press auto. The display will change to CAL.
5. Press -1 and +1 together to enter Dealer calibration.
6. In Dealer calibration, access the vessel type screen, using
vessel type screen shows either VESSEL or one of the vessel types (DISPLACE,
SEMI DISPLACE, PLANING, STERN DRV, WORK BOAT or SAIL BOAT).
Setting the vessel type
The vessel type setting automatically determines appropriate default values for
various other calibration settings. Some of these settings are checked later in this
procedure and others should not require any adjustment. The default values for each
vessel type are listed on page 58.
CAL screen
CAL screen
Yes
+
-1
+1
CAL screen
CAL screen
CALIBRATION
together to enter DEALER CAL
disp
if necessary. The
35
Leave
DEALER
D10807-1
D10540-1
Advertisement
Table of Contents
